Or, to create a new Geolocation action, click Add. From the Geolocation Control Action drop-down list, select a Geolocation action.To apply a Geolocation action in a policy: For more information about Geolocation, see Configure Geolocation. You can also add a new Geolocation action. If Geolocation is enabled on your Firebox, on the Geolocation tab, you can select the Geolocation action for this proxy. SD-WAN replaces policy-based routing in Fireware v12.3 or higher. For more information about SD-WAN routing, see About SD-WAN. On the SD-WAN tab, you can select to apply an SD-WAN action to the policy. To change the idle timeout that is set by the Firebox or authentication server, see Set a Custom Idle Timeout.If you set the Connections are drop-down list to Denied or Denied (send reset), you can block sites that try to use SMTP.įor more information, see Block Sites Temporarily with Policy Settings.To define the logging settings for the policy, configure the settings in the Logging section.įor more information, see Set Logging and Notification Preferences.See Configure Static NAT (SNAT) and Configure Server Load Balancing. You can also configure static NAT or configure server load balancing.Define the policy source and destination in the From and To list (on the Policy tab of the proxy definition).Connections are - Specify whether connections are Allowed, Denied, or Denied (send reset).You can use the settings on this tab to set logging, notification, automatic blocking, and timeout preferences. The Settings tab also shows the port and protocol for the policy, as well as an optional description of the policy. On the Settings tab, you can set basic information about a proxy policy, such as whether it allows or denies traffic, create access rules for a policy, or configure static NAT or server load balancing. Predefined proxy actions with Standard appended to the proxy action name include recommended standard settings that reflect the latest Internet network traffic trends. For a proxy policy that allows connections to your internal servers from the internet, use the Server proxy action. For a proxy policy that allows connections from your internal clients to the internet, use the Client proxy action. When you configure a proxy policy, you must select a proxy action appropriate to the policy. Enable Gateway AntiVirus in a Proxy Policy.You can also configure subscription service settings for the SMTP-proxy. To add the SMTP-proxy to your Firebox configuration, see Add a Proxy Policy to Your Configuration. Limit the email addresses that email can be addressed to and automatically block email from specific senders.Filter content embedded in email with MIME types and name patterns.Customize the deny message that users see when an email they try to receive is blocked.Adjust timeout, maximum email size, and line length limit to make sure the SMTP-proxy does not use too many network resources and can prevent some types of attacks.The SMTP proxy supports SMTPS connections on port 465 in Fireware OS v12.2 and higher. The proxy scans SMTP messages for a number of filtered parameters, and compares them against the rules in the proxy configuration. You can use the SMTP-proxy to control email messages and email content. SMTP (Simple Mail Transport Protocol) is a protocol used to send email messages between email servers and also between email clients and email servers over a TCP connection on port 25 or 465.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |